AIM for GENERAL ENGINEERING

YOUR ONLY DEDICATED ENGINEERING RESOURCE IN THE RED SEA

 © AIM for General Engineering 2019

Click on the map above to open a larger copy

AIM for General Engineering uses dedicated machinery operated by skilled and experienced technicians who can complete almost all aspects of mechanical engineering. Some of our key activities are listed below:

 

  • Grinding and finishing of bearing surfaces on camshafts and crankshafts to remove grooves or scoring from previous use and ready to accept after-market oversize shell bearings

 

  • Replacement and machining of new inlet and exhaust valve seats in cylinder heads

 

  • Re-grinding and seating of inlet and exhaust valves in cylinder heads

 

  • Milling and fine grinding of engine blocks and cylinders heads to remove warping or distortion

 

  • Straight and helical gear cutting

 

  • Vertical boring and finish honing of cylinder sleeves and liners

 

  • Horizontal boring for correct alingnment and seating of crankshaft and camshaft bearing faces in engine blocks and cylinder heads

 

  • Long bed lathe for machining and checking alignment of propeller drive shafts

 

  • Adjustments and modifactions to drive train suspension systems for engine, gearbox, driveshaft and propeller configurations

 

  • General cutting, welding and fabrication techniques